Lega DV2 Guide D'instructions page 13

2.0 PRELIMINARY OPERATIONS BEFORE USE
Knife adjustment
Fixing bolts
To facilitate centering the knives, the position "0"
relative to the knife shaft axle is marked on the lever (see
figure 2.1).
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
Remove the protective plexiglass shield
(figure 2), from the left side of the
Fig.2
machine.
Loosen the two bolts that secure the
two levers to the knives shaft.
Adjust the knifes opening until the
required cutting thickness is achieved
then tighten up to secure the bolts.
Replace the protective shield.
Grani di fissaggio
Fig.2.1
13 / 40