Troubleshooting - Ryobi P20010 Manuel D'utilisation

STORING THE TRIMMER
 Remove the battery pack from the string trimmer before
storing.
 Clean all foreign material from the trimmer.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
PROBLEM
Line will not advance when
using the auto-feed head
Grass wraps around boom
housing and string head
Motor fails to start when switch
trigger is depressed
MAINTENANCE

TROUBLESHOOTING

POSSIBLE CAUSE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground
level.
Battery is not secure.
Battery is not charged.
Shaft not connected
completely.
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
11 — English
REPLACEMENT PARTS
Replacement Spool Part Number:
0.065 in. Twisted ......AC14RSLA (1) or AC14RL3A (3 pk.)
0.080 in. Twisted ...........AC80RL1 (1) or AC80RL3 (3 pk.)
Replacement Spool Cap Part Number ................ AC14HCA
Lubricate with silicone spray.
Install more line. Refer to Line Replacement earlier in
this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
Cut tall grass from the top down to prevent wrapping.
To secure the battery pack, make sure the latches on
the battery pack are snapped into place.
Charge the battery pack according to the instructions
included with your model.
Make sure lower end is fully seated in the upper end
and screws are tightened securely.
CALL US FIRST
call the Ryobi Help Line!
SOLUTION