Troubleshooting - Ryobi RY15523A Mode D'emploi

ATTACHING THE STORAGE HANGER
See Figure 14.
There are two ways to hang the attachment for storage.
 To use the hanger cap, push in the button and place the hang-
er cap over the end of the attachment shaft. Slightly rotate
the cap from side to side until the button locks into place.
 The secondary hole in the attachment shaft can be used
for hanging purposes as well.
PROBLEM
Line will not advance when us-
ing the auto-feed head
Grass wraps around boom
housing and string head
MAINTENANCE

TROUBLESHOOTING

POSSIBLE CAUSE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground
level.
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
9 — English
STORING THE ATTACHMENT
 Store the attachment in a well-ventilated place that is
inaccessible to children.
 Keep away from corrosive agents such as garden chemi-
cals and deicing salts.
REPLACEMENT PARTS
0.080 in. Twisted Replacement Line (Bulk)............AC04138
0.080 in. Twisted Replacement Line (Pre-cut) .......AC04139
Available at homedepot.com
Lubricate with silicone spray.
Install more line. Refer to Line Replacement earlier in
this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
Cut tall grass from the top down to prevent wrapping.
CALL US FIRST
call the Ryobi Help Line!
®
SOLUTION