Abicor Binzel ABIMIG WT Mode D'emploi page 21

®
ABIMIG WT
®
ABIMIG 401/501 WT
®
ABIMIG 240/401/
501D WT
1
Gas nozzle
2
Contact tip
Fig. 1 Equipping the torch ABIMIG
4.2 Mounting the wire guide
4.2.1 Liner
Equip the torch neck according to the following figure:
1
3
Gas diffuser
4
Tip adaptor
®
401/501 WT/240/401/501 D WT
1 Screw the replaceable tip adaptor (4) to the torch neck (5)
®
(refers to ABIMIG
The following steps refer to all torch types.
2 Screw gas diffuser (3) onto tip adapter (4).
3 Screw the contact tip (2) into the tip adaptor (4) and tighten contact tip (2)
using a multiple wrench.
4 Slide the gas nozzle (1) on the torch neck rotating it slightly clockwise.
NOTICE
• Only use gas-tight, plastic-insulated wire guides to ensure a secure
shielding gas cover and a defined current contact.
• Bare liners give rise to a loss of shielding gas.
NOTICE
• New still unused spiral liners or PA liners have to be shortened to the
actual length of the hose assembly.
• To install the wire guide with a little preload, excess length required.
To be used for steel wires.
1 Unscrew torch neck from handle.
2 Disconnect cable assembly on machine side and lay it down straight.
2 3 4
5
240D/401D/501D WT).
4 Putting into operation
5
Torch neck
EN - 7