Velleman IREXT Mode D'emploi page 6

Application 2: Use with IR receiver extension
 Insert the plug of the IR probes [F] into the IR probes output
connection [B] at the back of the IR bender [A].
 Insert the plug of the IR receiver extension [E] into the IR
receiver extension input connection [C].
 Install the IR bender flat on a horizontal surface within sight and
reach of your remote control (± 6m in ideal circumstances) or
inside the cabinet.
 Stick the IR receiver extension preferably onto a vertical surface,
next the IR eye of the TV set.
 Lead the IR probes inside the cabinet and to the A/V equipment
in such way that a LED can be stuck onto the IR eye of each A/V
apparatus. Test the position of each LED first before sticking as
this should be done carefully and precisely.
 Insert the plug of the PSU into the PSU input connection [D] at
the back of the IR bender. Only use the supplied PSU. Connect
the PSU to the mains.
 Use your remote control and point towards the IR receiver
extension within an angle of ± 15° in all directions.
V. 02 – 27/09/2016
IREXT
6 ©Velleman nv