EINHELL MKA 2000M Mode D'emploi page 13

Anleitung MKA 3501 E SPK 1
Description of the control elements
MKA 3501 E
3 4 5 6 7 8 9 10
2
1
AUTO COOL
HI FAN
HEAT
LO
RT TIMER
ST
17
TEMP. UP TEMP. DOWN SPEED MODE TIMER ON/OFF
12 13
11 14
15 16
1. LED "Set temperature"
2. LED "Room temperature"
3. LED "Fan: Slow"
4. LED "Fan: Fast"
5. LED "Automatic mode set"
6. LED "Cool mode set"
7. LED "Fan mode set"
8. Not assigned
9. LED "Timer actuated"
10. LED "Compressor on"
11. "Warmer" selector
12. "Cooler" selector
13. "Fan speed" selector
14. "Mode" selector
15. "Timer" switch
16. On/off switch
17. LCD indicator panel
Switching the device on and off
Press the On/Off switch. The device starts up
automatically. If the ambient temperature:
is higher than 23°C the device will run in cooling
mode;
if it is between 20°C and 23°C the device will run
in fan mode.
The status of the device, or mode in which it is
running, will be shown by the corresponding LEDs
(see indicator panel).
Note: The "Compressor on" LED (COMP) only lights
up when the compressor is actually running. The
LCD indicator panel shows the current room
temperature.
To switch the device off, press the On/Off switch
again.
Selecting the mode
Press the "Mode" selector (MODE) in the sequence
"Automatic", "Cool", "Fan". The LED for the selected
mode lights up (see indicator panel).
Setting the set-point temperature
Press the "Warmer" selector (TEMP.UP) or "Cooler"
02.12.2004 10:16 Uhr
(TEMP.DOWN) to set your desired set-point
temperature. If you press the "Warmer" or "Cooler"
selector, the LCD indicator panel will show your
desired set-point temperature. Otherwise the LCD
indicator panel always shows the current room
temperature. The device's cooling mode is set to
24°C.
COMP.
Selecting the fan speed
Press the "Fan speed" selector (SPEED) to set the
desired fan speed.
The LED for the mode lights up (see indicator panel).
If the device is in "Automatic mode" (AUTO) the fan
speed will be selected automatically by the device in
dependency on the room temperature. The
corresponding LED lights up. The "Fan speed"
(SPEED) is deactivated.
Setting the timer
Press the switch for the "Timer" (TIMER) to set the
desired operating time (1 - 12 h). The "Timer"
(TIMER) LED lights up. If the timer is set, the device
starts automatically. If you press the "Timer" switch,
the time you have set will be shown in the LCD
indicator panel. If the timer has not been switched
on, the device will run continuously.
If you press the switch for the "Timer" (TIMER)
without any of the other modes being switched on
you can set the time that the device is to start up.
If, for example, the timer shows "2", this means that
the device will start up automatically in 2 hours time.
All modes and functions can be set using the
supplied remote control.
The remote control requires two MICRO (AAA)
batteries.
In order to protect the compressor, it only starts up 3
minutes after the device starts up. The same applies
when the device is switched off.
The cooling system switches itself off whenever the
room temperature is below the value set on the
thermostat. The air circulation/ventilation fan
continues to run as set. If the room temperature
increases again, the cooling system switches on
again.
Seite 13
GB
13