Sony STR-DA1800ES Mode D'emploi page 97

Operating the receiver from
zone 2
The following operations are described for
connecting an IR repeater and operating the
receiver in zone 2. When an IR repeater is not
connected, use this receiver in the main zone.
AV ?/1
Input
buttons
SOURCE
1
Turn on the main receiver (this
receiver).
2
Turn on the receiver in zone 2.
3
Press ZONE.
The remote control switches to zone 2.
4
Press ?/1.
The zone function is activated.
5
Press the input buttons to
select the source you want.
For zone 2, HDMI signals, component
video signals, analog audio and video
signals are output.
When you select SOURCE, the signals of
the current input in main zone are output.
6
Adjust to a suitable volume
using the receiver in zone 2.
To exit the zone 2 operation
Press ZONE, then press ?/1.
Tips
• Even when this receiver is in standby mode (press
?/1 on the remote control to turned off this
receiver), the receiver in zone 2 remains turned on.
To turn off all receivers, press ?/1 and AV ?/1 on
the remote control at the same time (SYSTEM
STANDBY).
• When the receiver is in standby mode, the
ON/STANDBY indicator on the front panel lights
up in amber if the receiver in zone 2 is turned on.
• Signals from equipment connected to the HDMI
?/1 input jack, component video input jack and analog
input jacks are output through the ZONE 2 OUT
ZONE
jacks. No signals are output from equipment
connected to only the digital input jacks. It does not
support upconversion/downconversion for zone 2
(page 20).
• The USB, AirPlay, HOME NETWORK,
BLUETOOTH and SEN inputs can be selected in
main zone only.
• When SOURCE is selected, the signals input to the
DIGITAL IN jacks and USB port are not output
from the ZONE 2 OUT jacks.
• When SOURCE is selected, the HDMI signals,
component video signals, analog audio and video
signals from USB, AirPlay, Home Network,
Bluetooth and SEN are not output from the ZONE
2 OUT jacks.
• You can select either "FM" or "AM" from the main
zone and zone 2. Priority is given to the choice
which has most recently been selected, even if a
different choice has already been selected in one of
the zones.
• When "Zone2 / OutB" setting is "Zone2", you can
use HDMI OUT B for zone 2.
• HDMI OUT for zone 2 can select only HDMI input
signal.
US
97