Charge and turn on the system
Charging the system
Connect the items as shown in the illustration below and charge the system.
Nintendo logo
facing upwards
Note: The illustration above shows the UK version of the AC adapter.
Turn the power on
Press the POWER Button
6
Recharge LED lit
(The LED will go out when
charging is complete.)
The stylus is used to operate the Touch Screen.
Remove the stylus
Configure the system
You must configure the system after turning it on for the first time.
1
Select your language
2
3D calibration
Look directly into the
Allow a distance of 30 – 40 cm
3D Screen
between your eyes and the screen
Touch your language, then touch OK.
Move the 3D depth slider to the upper-
most position, then touch NEXT.
Hold the system as shown in the
illustration, then touch NEXT.
Touch ACTIVATE 3D and the images
shown on the upper screen will
appear in 3D.
Use the 3D depth slider to adjust the
3D effect to a comfort able level, then
touch DONE.
7