Vitrifrigo C51i Sea Classic Notice D'emploi page 21

DESCRIPTION OF THE APPLIANCE (Fig. 2 and Fig. 7)
12/24Vcc – 220Vca
A) Horizontal evaporator
A1) Vertical evaporator
B) Drip tray
C) Thermostat housing
D) Removable wire racks
E) Glass shelf (on some models only)
F) Salad drawer (on some models only)
G) Door compartments (removable)
The data plate bearing the serial number and technical data is located on the upper right-
hand section, inside the refrigerator. The first three figures of the serial number indicate
the year and week of manufacture.
All materials exposed to contact with food comply with EC directive 2004/1935.
Noise emission levels are maintained below 70 dB (A).
INSTALLATION
Ensure that the appliance is in no way damaged. Any damage resulting from transport
must be reported to the dealer no later than 24 hours after delivery.
Handle the appliance with care. Take care when positioning the refrigerating unit (in
the case of refrigerators with remote refrigerating units) to avoid breaking the
connection pipelines or obstructing them in any way.
refrigerator and remote refrigerating unit (where supplied) are installed on a flat surface.
For built-in installation, cut two holes in the cupboard that will accommodate the
refrigerator: one at the bottom next to the refrigerating unit and the second in the top or
on the upper half of the side. The holes must have an area of at least 300 cm². If this is
not possible, leave a gap of at least 50 mm between refrigerator top and the interior
surface of the top of the cupboard (see Fig. 5).
Install the refrigerator away from heat sources in dry and well-ventilated surroundings.
Leave the appliance for at least one hour before switching on. In the meantime the
appliance should be cleaned for the first time.
12/24Vcc Portatili
A) Basket
B) Pawl closure
C) Evaporator
D) Bracket fastening screw
E) Fixing bracket
F) Mount with digital thermostat
G) Mount with LED thermostat
H) Manual thermostat (C26 only)
I) Switch (C26 only)
J) Handle
K) 12/24 V DC – 220 V AC socket
21
Always ensure that the