Connecting To Host Computer (Parallel Interface); Connecting To A Peripheral Unit - Star SP2000 Série Mode D'emploi

5-3. Connecting to Host Computer (Parallel Interface)

Fig.5-5 Connecting the parallel
interface cable

5-4. Connecting to a Peripheral Unit

You can connect a peripheral unit to the printer using a modular plug. See
"Modular plug" on page 142 for details about the type of modular plug that is
required. Note that this printer does not come with a modular plug or wire, so it
is up to you to obtain one that suits your needs.
Important!
Make sure that the printer is turned off and unplugged from the AC outlet and
that the computer is turned off before making connections.
Modular plug: MOLEX 90075-0007,
AMP641337, or JAPAN BURNDY B-66-4
Ferrite core
Fig. 5-6
– 10 –
1 Turn off power to both the host
computer and the printer.
2 Insert one terminal of the interface
cable into the printer's connector,
as shown in the diagram, and fasten
it there with the clasp.
3 Insert the other terminal of interface
cable into the host computer's con-
nector, and again fasten it with the
clasp.
Shield
Wire lead
Modular
plug
Fig. 5-7
Cable