Optional Near-End Sensor; Adjusting The Near-End Sensor - Star SP2000 Série Mode D'emploi

The near-end sensor detects when the roll of paper loaded in it is reaching the end.
The near-end sensor is normally disabled when the printer is shipped from the
factory, but it can be enabled by your dealer using the memory switch. The
information in this chapter applies only to printers whose near-end sensor is
enabled.
Important!
Installation of the near-end sensor should normally be left to your dealer.

8-1. Adjusting the Near-end Sensor

Use the following procedure to adjust the near-end sensor so it is compatible with
the size of roll paper you are using.
Important!
Regardless of the overall diameter of the paper roll, the heavy paper core at the
center off the roll must have an inside diameter of 12 mm and an outside
diameter of 18 mm for proper detection.
Fig. 8-1

8. Optional Near-end Sensor

– 30 –
1 Make sure that the printer is turned
off and unplugged from its power
outlet.
2 Remove the printer cover.
3 Remove the roll paper.