Appendix A: General Specifications - Star SP2000 Série Mode D'emploi

Appendix A: General Specifications

Printing method:
Print direction:
Number of head pins:
Number of print columns:
Character set:
Font configuration
Printing width:
Print speed:
Line spacing:
Paper feed method:
Paper feed speed:
Paper specifications
Paper type:
Paper width:
Roll diameter:
Internal diameter of roll:
Thickness
Serial impact dot matrix
Bi-directional
9 wires
42 columns
ASCII
Extended graphics: 128 × 40 pages
International characters: 46 (Star mode)
7 (Half dots) × 9 or 5 × 9
63 mm, 210 dots
Approx. 3.1 lines per sec.
1/6-inch (default), n/144-inch (programma-
ble by command)
Friction feed
Approx. 3.5 inches/sec.
Ordinary bond and carbonless copy paper
76±0.5 mm (3.0 inches)
85mm (3.35 inches) max.
12±1 mm
Note: The paper must not be glued to the core.
SP2300 (single) 0.07 mm to 0.10 mm
(copies) Original + 2 copies (Max. 0.2 mm)
SP2500 (single only) 0.07 mm to 0.10 mm
Note: The auto-cutter that is fitted to the SP2500 series
is designed to cut single ply paper to a maximum
thickness of 0.1mm. Cutting multi-ply paper, or
paper thicker than 0.1mm is not recommended as
the specifications of the auto-cutter cannot be
guaranteed.
– 128 –
96 (characters)
(Star mode)
128 × 6 pages
(ESC/POS)
37 (ESC/POS)