Removing The Paper - Star SP2000 Série Mode D'emploi

6-3. Removing the Paper

Remove the cover, then cut off the paper near the rear of the paper guide and press
the FEED switch to feed out the paper remaining in the unit.
When the paper runs out, the POWER lamp will blink.
Note: 1. Remove the paper remaining in the printer by pressing the FEED
switch.
2. When the paper end mark appears on the paper, replace the roll
paper before it runs out.
[When the rewinder is used]
Remove the reel together with the paper rolled up on it.
Spool
Fig. 6-24
– 23 –
Paper
Reel