Ferrite Core Installation *Europe Only; Parallel Interface - Star TSP400Z Série Mode D'emploi

3. Ferrite core installation
NOTE: Take special care when following the procedures listed below.

3-1. Parallel interface

Ferrite core is packed so it is open, as
shown in Fig. 3-2. If you find that a
ferrite core is not open, use a pointed
object to pry the plastic lock of the
ferrite core apart (Fig. 3-1). When
you do this, take care not to damage
the ferrite core or the plastic lock.
Parallel interface
Cable
Fig. 3-2
Clamp the ferrite core onto the interface cable as shown in Fig. 3-2. Take care
to avoid damaging the interface cable when installing the ferrite core. The
ferrite core should be anchored firmly in place with the fastener that comes
with it, as shown in Fig.3-3 and 3-4.
Ferrite Core
Pass fastener through ferrite core.
Pass fastener around cable and lock it.
Cut off excess with scissors.
– 3 –
*Europe only
Fig. 3-1
5 cm
maximum
Parallel interface
Fig. 3-3
Fig. 3-4
Fastener
Pull and cut