Unpacking And Inspection; Unpacking; Handling Notes - Star TSP400Z Série Mode D'emploi

1. Unpacking and inspection

1-1. Unpacking

Check each item in the box against Fig. 1-1 to make sure that you have everything.
If any of these items are missing, contact your supplier.
*1 The Ferrite core is included only with printers marketed in Europe.
Two are parallel interface models and one is serial interface model.
*2 A fastener is included only with printers marketed in Europe.

1-2. Handling Notes

Before you start setting up your printer, make sure that you have a suitable place
in which to locate it. By "a suitable place", we mean:
• Close to an easily accessible socket-outlet.
• A firm, level surface which is fairly vibration-free.
• Away from excessive heat (such as direct sunlight, heaters, etc).
• Away from excessive humidity.
• Away from excessive dust.
• With access to a steady power supply that is not subject to power surges. For
example, do not connect the printer to the same circuit as a large, noise-
producing appliance such as a refrigerator or an air conditioner.
NOTE: Make sure that the line voltage is the voltage specified on the printer's
identification plate.
Paper-roll shaft
Printer
Fig. 1-1
– 1 –
Sample paper roll
Ferrite core(s)
(*1)
User's manual
Fastener
(*2)