Peripheral Unit Cable - Star TSP400Z Série Mode D'emploi

3-2. Peripheral unit cable

Clamp the ferrite core onto the cable of the peripheral unit using the same
procedure as you do for the parallel interface cable ferrite core. With the
peripheral unit cable ferrite core, however, you have to loop the cable as shown
in Fig. 3-5.
NOTE: The ferrite cores only need to be attached for the European region (only
printers marketed in Europe are eligible.)
Install both the parallel interface model and the serial interface model.
5 cm or less
Ground wire
Fig. 3-5
– 4 –
Ferrite core
One loop