Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation
■
Securing to audio board
1
Attach the installation brackets to the
bottom of the KVA-S300 using the binding
screws (ø3 x 6mm).
2
Mount the KVA-S300 to an audio board using
the self-tapping screws (ø4 x 12mm).
■
Securing to the body of the vehicle
Peel off the protection paper from the Velcro strip
(Accessory 3) and paste the one side to the
bottom of the KVA-S300 and the other side to the
body of the vehicle.
2CAUTION
Please do not install the unit near the
dashboard, the rear tray, or other important
components. Doing so could lead to injury or
accident should the unit come off due to a
shock and strike a person or an important
component.
Tapping screws should be used for mounting.
(Attachment with velcro strips, although easy,
can come off with a shock.)
Attaching the remote controller
1
Clean the place where you want to attach
the remote controllor with a detergent to
remove dirt or oil and wipe the surface with
a soft dry cloth.
2
Attach the remote controller to the center
console or any convenient place using the
supplied Velcro strips.
NOTE
If you find that the Velcro strips (Loop:
Accessory5) will not attach to the center
console surface, provide the double-sided
adhesive tape (Accessory6) to the Velcro for
secure attachment. (Paste the yellow
protection paper side to the Velcro strip and
the transparent protection paper side to the
body of the vehicle.)
4-
English
Installation board,etc.
(thickness:15mm or more)
Installation
brackets
(Accessoryw)
Velcro strips
5
(Loop:Accessory
)
Tapping screw
(ø4X12mm)
(Accessoryi)
Tapping screw
(ø3X6mm)
(Accessoryu)
Velcro strips
(Accessorye)
Velcro strips
4
(Hook:Accessory
)
Publicité
Table des Matières
