Kenwood KVA-S300 Mode D'emploi page 2

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
Installation
Safety precautions
2WARNING
To prevent injury or fire, take the following precautions:
• Insert the unit all the way in until it is fully locked in place. Otherwise it may fall out of place when
jolted.
• When extending the ignition, battery, or ground wires, make sure to use automotive-grade wires or
other wires with a 0.75mm
coating.
• If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your
Kenwood dealer.
2CAUTION
To prevent damage to the machine, take the following precautions:
• Make sure to ground the unit to a negative 12V DC power supply.
• Do not open the top or bottom covers of the unit.
Accessories
Part name
Remote controller
q
(cable length:5m)
Installation
w
bracket
Velcro strips
e
(
20x60mm)
Velcro strips
r
(Hook :
12x65mm)
2CAUTION
The use of any accessories except for those provided might result in damage to the unit. Make sure
only to use the accessories shipped with the unit, as shown above.
Installation procedure
1. Remove the ignition key and disconnect the negative - terminal of the battery to prevent short
circuits.
2. Set the unit according to the intended usage.
3. Connect the input and output cables of the units.
4. Connect the Ignition wire and grounding wire following this order.
5. Install the unit in the car.
6. Connect the negative - terminal of the battery.
2CAUTION
• Be sure to turn the power off before changing the setting of any switch.
• If the fuse blows, check cables for shorts, then replace the fuse with one of the same rating.
• Check that no unconnected wires or connectors are touching the car body.
• After installation, check that the brake lamps, winkers, and wipers work properly.
2-
English
2
(AWG18) or more to prevent wire deterioration and damage to the wire
External view
......... Number of items
.........1
.........2
.........2
.........2
Part name
Velcro strips
t
(Loop :
25x70mm)
Double-side
y
adhesive tape
Tapping screw
u
(
ø3x6mm)
Tapping screw
i
(
ø4x12mm)
External view
......... Number of items
.........2
.........2
.........4
.........4

Publicité

Table des Matières
loading

Table des Matières