Sammic SU-416GP Mode D'emploi page 12

• The exhaust filter must be replaced every four
oil changes or when oil leaks or oil mist are
observed in the exhaust.
COMMENTS
If, when the machine is in the vacuum cycle,
the sensor detects that the vacuum pressure
does not reach the programmed setpoint, after
a waiting time the cycle is stopped and changed
to the decompression process.
If, upon initiating the decompression process,
the lid does not open, after a time the
decompression electro-valve disconnects to
prevent damage to the valve or to the electronic
board.
Other important information:
- Appliance for commerical use only.
- WARNING: Disconnect the electric power
before servicing.
- This machine is not designed for use by people
(including children) with reduced physical,
sensory or mental capabilities or lacking the
necessary experience or knowledge, unless
they have received supervision or instructions
from someone responsible for their safety.
- Children must be supervised to ensure that
they do not play with the device.
- Cover cleaning:
Warning !
Never use alcohol, solvents or glass-cleaning
products to clean the cover, because they
may affect the mechanical properties of the
material, eventually resulting in damage to
the cover. Instead, wash the cover with water
and soap. If you ever observe any crack in the
cover, stop operating the machine and call the
authorised assistance service to come and
repair the cover, as there is a risk for the cover
to break.
-Vacuum Pump oil:
Warning
Vacuum pump contaisn oil, do not tilt the
machine.
EN
12