Setting The Time Zone; Light On/Off; Warranty Disclaimer - Hama RC40 Mode D'emploi

5.6. Setting the time zone

• Press and hold the + button (3) for 3 seconds. The T icon appears.
• In the time zone and temperature display, press and hold the MODE button (5) for 3 seconds. You can set
the time zone (hours only) by pressing the + or – button (3).
• Press the MODE button (5) again to confirm the time zone setting.
• Press and hold the + button (3) for 3 seconds to switch between the displays of local and foreign times.
5.7. Adjusting the time zone
Setting range: only +/– 1 hr. Press and hold + or – for about 2 seconds to quickly change the time zone by
+/– 1 hour. This range covers all current European countries (CET +/–1). If the time zone is adjusted, the time
+1 -1
zone icon and/or or will be displayed.

5.8. Light on/off

When you press the SNOOZE/LIGHT (1) button, the backlighting is switched on and then switched off again
automatically after 5 seconds.
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.

7. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
9. Technical Data
RC40 travel alarm clock
1,5V
Power supply
1 x AA battery
5