Replacing The Door Panel - Dometic RMD8 1 Série Notice D'utilisation

RMD8xxx
➤ Only for direct/alternating current operation, not for gas operation:
Attach the winter cover (2) to the upper grille.
7.13 Operation at high ambient temperatures
At high outside temperatures in combination with high levels of humidity, condensa-
tion may form on the freezer compartment frame. The freezer compartment is fitted
with a frame heater (12 Vg/3.5 W). Switch the frame heater on to prevent conden-
sation from forming on the frame of the freezer compartment.
The frame heater is switched on continuously in the following operating modes (no
display):
• AC operation
• Automatic operation (only RMD8xx5, RMD8xx6)
A
NOTICE!
Do not switch the frame heater to permanent operation when the refrig-
erator is being operated with gas. This could discharge the on-board
battery.
Proceed as follows to switch on the frame heater:
➤ Press the
button to set the frame heater as follows:
– Press the button once for a 2-hour setting; the temperature display shows one
bar
– Press the button twice for a 5-hour setting; the temperature display shows
two bars
– Press the button a third time for continuous operation; the temperature dis-
play shows three bars
– Press the button a fourth time to switch it off; the temperature display goes off
7.14

Replacing the door panel

A
NOTICE! Risk of damage!
The door panel must not be replaced when the refrigerator is upright.
Removing the decorative trim with frame
Proceed as follows (fig. d, page 8):
➤ Remove the door trim carefully. It is only clipped in and held in place by small
hooks.
➤ Pull the old panel away from the door trim still installed.
EN
Using the refrigerator
33