easydriver infinity 2.5 Instructions D'assemblage Et Mode D'emploi page 35

7. Commissioning / operation ž ‚
B5 Direction buttons
You can press any of the movement buttons singly or
together. The arrows on the buttons show the respec-
tive direction of movement.
Driving forward
Both drive units (left and right) pull
forwards with full power
Turn towards the right front
Only the left drive unit pulls forwards
with full power. The right drive unit is
blocked.
Turn towards the left front
Only the right drive unit pulls for-
wards with full power. The left drive
unit is blocked.
Turn towards the right rear
Only the left drive unit pulls back-
wards with full power. The right drive
unit is blocked.
Turn towards the left rear
Only the right drive unit pulls back-
wards with full power. The left drive
unit is blocked.
Driving backwardst
Move both drive units (left and right)
in reverse at full power
Left turn on the spot
The right drive unit pulls forwards
with full power. The left drive unit
pulls backwards with full power.
Right turn on the spot
The left drive unit pulls forwards with
full power. The right drive unit pulls
backwards with full power.
Arc towards the front right
The left drive unit pulls forwards with
full power. The right drive unit pulls
forwards with reduced power
Arc towards the front left
The right drive unit pulls forwards
with full power. The left drive unit
pulls forwards with reduced power
Arc towards the rear right
The left drive unit pulls backwards
with full power. The right drive unit
pulls backwards with reduced power
Arc towards the rear left
The right drive unit pulls backwards
with full power. The left drive unit
pulls backwards with reduced power
Buttons for automatic enga-
ging / disengaging. Both but-
tons have to be pressed at the
same time. During engaging
or disengaging the related
symbol is flashing.
The system indicates the final position be showing a
permanent light symbol. If, either the engaging or di-
sengaging operation is interrupted, or the final positi-
on can not be detected, an acoustic signal will be he-
ard (3 beeps) and the corresponding light is flashing.
In this case you have to check to correct po-
sition of the drive units!
GB13