easydriver infinity 2.5 Instructions D'assemblage Et Mode D'emploi page 30

6. Installation, electrical system ž
Should the Bluetooth device (e.g. smartphone) on
which you are using the app go into standby mode
and therefore lose the Bluetooth connection, switch
the base station off and on again once to establish
a new connection with the easydriver app controller.
The Bluetooth connection will be restored automati-
cally after the restart.
Bluetooth module installation:
The app controller is supplied with a 4 metre cable.
When installing the module, make sure that as few
components as possible are located between the
smartphone/tablet and the Bluetooth module.
The module may only be mounted inside the caravan.
Install the module inside the caravan as high up as
possible, e.g. in a wardrobe or on the ceiling.
Mount the module using the sticky pad on the back.
The module can also be mounted by inserting suita-
ble screws through the bore holes provided (screws
not supplied).
Now route the cable to the base station.
Remove the housing cover from the base station.
Now attach the connector to the base station as
shown in the figure below.
GB8
App-Controller
‡
App installation/registration:
Download the easydriver app from the iOS Apple
Strore or the Google Play Store.
iOS
(Version 11.3 or later)
https://itunes.apple.com/de/app/easydriver/id1423125015?mt=8
Android
(Version 6.0 or later)
https://play.google.com/store/apps/details?id=com.reich.easydriver