Sony Aplha ILCE-7SM2 Mode D'emploi page 61

Auto
Manual
Notes
• The SteadyShot function may not work optimally when the power has just been
turned on, right after you point the camera towards a subject, or when the shutter
button has been pressed all the way down without stopping halfway.
• When using a tripod, deactivate the SteadyShot function because there is a potential
for malfunction of the SteadyShot function.
• When the camera cannot obtain focal length information from the lens, the
SteadyShot function does not work correctly. Set [SteadyShot Adjust.] to [Manual]
and set [SteadyS. Focal Len.] to match the lens you are using. In this case, the
currently set SteadyShot focal length value will be displayed to the side of
• When using an SEL16F28 lens (sold separately) with a teleconverter, etc., set
[SteadyShot Adjust.] to [Manual] and set the focal length.
• Switching [SteadyShot] [On]/[Off] will simultaneously change the setting both in
the camera body and the lens.
• When a lens with a SteadyShot switch is attached, the settings can be changed only
by operating the switch on the lens. You cannot change the settings on the camera.
Shooting a clear image without camera shake
Analyzes the lens information and automatically
compensates for camera shake.
Compensates for camera shake using the focal length set with
[SteadyS. Focal Len.] (8mm – 1000mm).
• Set the focal length of the lens for shooting.
GB
.
GB
61