Installation Manual - Selecting The Installation Place - Vesta VAC-09CH Manuel D'installation Et D'utilisation

INSTALLATION MANUAL - SELECTING THE INSTALLATION PLACE

INDOOR UNIT
● Install the indoor unit on a strong wall that is not
subject to vibrations.
● The in let and outlet ports should not be obstructed:
the air should be able to blow all over the room.
● Do not install the unit near a source of heat, steam, or
flammable gas.
● Do not install the unit where it will be exposed to
direct sunlight.
● Select a site where the condensed water can be
easily drained out, and where it is easily connected to
outdoor unit.
● Check the machine operation regularly and reserve
the necessary spaces as shown in the picture.
● Select a place where the filter can be easily taken out.
OUTDOOR UNIT
● Do not install the outdoor unit near sources of heat,
steam or flammable gas.
● Do not install the unit in too windy or dusty places.
● Do not install the unit where people often pass. Select
a place where the air discharge and operating sound
will not disturb the neighbours.
● Avoid installing the unit where it will be exposed to
direct sunlight (other wise use a protection, if neces-
sary, that should not interfere with the air flow).
● Reserve the spaces as shown in the picture for the air
to circulate freely.
● Install the outdoor unit in a safe and solid place.
● If the outdoor unit is subject to vibration, place rubber
gaskets onto the feet of the unit.
Installation diagramm
indoor unit
The purchaser must ensure that the person and/or company who is to install, maintain or
repair this air conditioner has qualifications and experience in refrigerant products.
EN
outdoor unit
21
mounting plate
150
condensed water drain pipe
sleeve
insulating covering
electrical cable
water drain pipe
minimum space to be reserved
(mm) showing in the picture
indoor unit
outdoor unit
KEN002VAC
v1• 11.11.2020
150
300