Self-Clean Function - Vesta VAC-09CH Manuel D'installation Et D'utilisation

SELF-CLEAN FUNCTION

Switch off the air conditioner by pressing
Press [OPTION] at the first time, select the CLEAN by pressing the button
or until symbol CLEAN is flashing; Press [OPTION] again to
activate the CLEAN function, and [CLEAN] appears on the display.
Do it again to deactivate this function.
1. This function help carry away the accumulated dirt, bacteria, etc from
the evaporator.
2. This function will run about 30 minutes, and it will return to the pre-set-
ting mode. You can press
the process. You will hear 2 beeps when it's finished or cancelled.
3. It's normal if there are some noise during this function process, as
plastic materials expand with heat and contract with cold.
4. We suggest operate this function as the following ambient condition to
avoid certain safety protection features.
Indoor unit
Outdoor unit
5. We suggest operate this function per 3 months
8°C HEATING FUNCTION (OPTIONAL)
1. Press [OPTION] at the first time, select the 8°C H by pres-
sing the button
Press [OPTION] again to activate the 8°C heating function,
and [8°C H] appears on the display.
Do it again or change the mode to deactivate this function.
2. If the air conditioner is in standby, this function enable the
air conditioner to automatically start heating when the indoor
temperature is equal or lower than 8°C, it will return standby if
the temperature is equal or higher than 18°C.
[CLEAN]
.
or [Mode] to cancel this function during
Temp < 30°C
5°C < Temp < 30°C
or until symbol 8°C H is flashing;
EN
[8°C H]
15
KEN002VAC
v1• 11.11.2020
OPTION
TURBO
ECO
MODE FAN