Fitting Procedure - Sony SDTI Manuel D'installation

Fitting Procedure

1
2
Remove the DSR-70/70P battery panel (four screws) and
cover plate (two screws).
Note
Take care not to lose the cover plate or screws.
Insert the connector panel and its attached cables into the
hole left by the cover plate. Pull the two cables one at a
time through the DSR-70/70P board slot space and up to
the top.
Secure the connector panel using the screws removed from
the cover plate in step 1.
Battery panel
Screws
Cover plate
Connector panel
Screws
(Continued)
15