Operation - EINHELL GE-CC 18 Li Mode D'emploi D'origine

Important! Be sure to remove the pin again
from the shaft.
To dismantle the equipment for changing the
brush proceed in reverse order.
5.2 Height adjustment (Fig. 8/Item 5)
Undo the union nut (Fig. 8/Item 18) until the patio
cleaner's handle can be moved in and out freely.
Now set the required working height and secure
the handle in this position by tightening the union
nut again.
5.3 Adjusting the additional handle (Fig. 9)
Undo the adjustment lock (Fig. 8/Item 3) for the
additional handle until it can be moved forwards
and backwards without any great resistance. Set
the required position and tighten the securing
screw again.
5.4 Installing the battery (Fig. 10/11)
Press the pushlock button (Fig. 12/Item 19) of the
battery pack as shown in Fig. 10 and push the
battery pack into the mount provided. When the
battery is positioned as in Fig. 11, make sure that
the pushlock button latches in place! To remove
the battery pack, proceed in reverse order.

6. Operation

To obtain maximum performance from your patio
cleaner, please follow the instructions given
below:
•
Never use the patio cleaner without the guard.
•
To switch on your patio cleaner, press the
safety lock-off button (Fig. 2/Item 1) and the
On/Off switch (Fig. 2/Item 2).
•
To switch off your patio cleaner, let go of the
On/Off switch again (Fig. 2/Item 2).
One steel brush (Fig. 2/Item 9) and one nylon
brush (Fig 2/Item 8) are supplied with the product.
The steel brush is suited for use on robust
surfaces and obstinate weeds. We recommend
using the nylon brush for light vegetation and
surfaces too sensitive for the steel brush.
Important! Always carry out a short trial run
to check out possible eff ects on the surfaces
of the paving stones or slabs before starting
with your work. Never use the equipment on
very sensitive surfaces, for example tiles.
Anl_GE_CC_18_Li_USA_SPK7.indb 11 Anl_GE_CC_18_Li_USA_SPK7.indb 11
EN
Important! Only use brushes which are in
fl awless condition. Replace excessively worn
or damaged brushes immediately. Always use
both hands to operate the equipment. Guide the
equipment along the joints at a walking pace. For
uniform results carry out your work at a constant
speed. If necessary, guide the equipment along
the same joint several times.
6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Battery capacity indicator (Fig. 12 /
item 20)
Press the battery capacity indicator switch (21).
The battery capacity indicator (20) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
- 11 -
13.02.2020 13:05:42 13.02.2020 13:05:42