Before First Use - Outdoorchef GENEVA 570 G Mode D'emploi

BEFORE FIRST USE

1. Clean all parts that come into contact with foodstuffs.
2. Check all parts that carry gas, as described in the CHECKING FOR LEAKS chapter. Also do this if your gas kettle barbecue was delivered
already assembled by the retailer.
3. Let the barbecue burn for about 20–25 minutes at the
INSTRUCTIONS FOR LIGHTING
1. Make sure that all connections between the gas hose, the gas pressure regulator and the gas bottle are firmly tightened. (Follow the
instruction in the CHECKING FOR LEAKS chapter.)
2. Open the barbecue lid. CAUTION: Never light the barbecue when the lid is closed.
3. Open the gas supply at the gas bottle.
4 a. Models with one ring burner:
Press the gas regulating knob and turn it anticlockwise to the
catches and the gas is burning. (Fig. 1C)
4 b. Models with two ring burners and a separate ignition button:
Press the gas regulating knob for the large ring burner and turn it anticlockwise to setting
Press the black ignition button and hold it until the spark catches and the gas is burning.
Alternatively press the gas regulating knob for the small ring burner (left knob) and turn it anticlockwise to setting
Press the black ignition button and hold it until the spark catches and the gas is burning. (Fig. 1D)
4 c. Models with two ring burners without a separate ignition button:
Press the gas regulating knob for the large ring burner and turn it anticlockwise to setting
Press the gas regulating knob and hold it until the spark catches and the gas is burning. (Fig. 1E)
Alternatively press the gas regulating knob for the small ring burner (left knob) and turn it anticlockwise to setting
Press the gas regulating knob and hold it until the spark catches and the gas is burning.
5. If the gas does not light within 3 seconds, set the gas regulating knob to
repeat point 4.
6. If it is not possible to light the barbecue after 3 attempts, check the causes (as described in the TROUBLESHOOTING section).
INSTRUCTIONS FOR LIGHTING THE CITY 420 G / CHELSEA 420 G / MINICHEF 420 G
1. Make sure that all connections between the gas hose, the gas pressure regulator and the gas bottle are firmly tightened
(Follow the instruction in the CHECKING FOR LEAKS chapter). NOTE: For the MINICHEF 420 G, the side shelves must be folded out the
entire time the barbecue is in use.
2. Open the barbecue lid. CAUTION: Never light the barbecue when the lid is closed.
3. Open the gas supply at the gas bottle.
4. Press the gas regulating knob and turn it anticlockwise to the
lights. (Fig. 1F)
5. If the gas does not light within 3 seconds, set the gas regulating knob to
repeat point 4.
6. If it is not possible to light the barbecue after 3 attempts, look for the causes (as described in the TROUBLESHOOTING section).
setting.
setting. Press the black ignition button and hold it until the spark
. Wait 2 minutes to allow the uncombusted gas to dissipate. Then
setting. Press the red ignition button several times until the gas
. Wait 2 minutes to allow the uncombusted gas to dissipate. Then
17
OUTDOORCHEF.COM
.
.
.
.