Resetting The Zero Point Correction; Automatic Power Off - WEBTEC HPM110 Mode D'emploi

5.9 Resetting the zero point correction

Turn off the device. Zero point correction is no longer
active when the device is turned off and on again.

5.10 Automatic power off

Press for 2 seconds.
Depending on the device configuration, two different displays
are possible:
Auto Power Off
PO On
Press . Auto Power Off
is activated after 5 minutes.
The settings Auto Power Off or Continuous operations
remain stored and are active when the device is turned
off and on again.
Continuous operations
PO OFF
Press
be turned off manually.
17
. The device must