Haussmann FS7AUL Manuel De L'utilisateur page 11

ADDITIONAL SAFETY RULES FOR TABLE SAWS
•
Disconnect power before changing blade or servicing.
Wear hearing protection.
Wear eye protection.
Wear respiratory protection
EXTENSION CORDS
•
Replace damaged cords immediately. Use of damaged cords can shock,
burn or electrocute.
•
If an extension cord is necessary, a cord with adequate size conductors
should be used to prevent excessive voltage drop, loss of power or overheating.
The table shows the correct size to use, depending on cord length and nameplate
amperage rating of tool. If in doubt, use the next heavier gauge. Always use U.L.
and CSA listed extension cords.
RECOMMENDED SIZES OF EXTENSION CORDS
Tool's Ampere
Volts
rating
25 ft (7.6 m)
3–6 120V~
6–8 120V~
8–10 120V~
10–12 120V~
12–16 120V~
OPERATING INSTRUCTIONS
ACCESSORIES
The FS7AUL is supplied with the following accessories as standard
•
Rip fence
•
Workpiece clamp
•
Cross cut fence
•
Hex key
•
Push stick
•
Dust bag
UNPACKING
Due to modern mass production techniques, it is unlikely that your HAUSSMANN
Power Tool is faulty or that a part is missing. Check immediately whether all
parts and accessories are included. If anything is missing, or broken, contact the
RONA Customer Service at 1-866-599-5916 ext. 2. If you find anything wrong,
do not operate the tool until the parts have been replaced or the fault has been
rectified. Failure to do so could result in serious personal injury.
The laminate saw can be used to make a variety of cuts including longitudinal
cuts, mitre cuts and cross cuts.
RIP CUT
A cutting operation where the blade cuts along the length of the laminate
floorboard / workpiece.
CROSS CUT
A cut made across the width of the workpiece cutting the workpiece to length.
20
Total length of cord in feet. Cord size in
A.W.G. (minimum)
50 ft (15 m) 100 ft (30 m) 150 ft (46 m)
18 16 16
18 16 14
18 16 14
16 16 14
14 12 -
OPERATING INSTRUCTIONS
14
12
12
12
-
RIVING KNIFE
Also known as a separator or spreader. The riving knife is a metal piece slightly
thinner than the saw blade which helps keep the kerf open during cutting
operations and prevents kickback.
PUSH STICK
A device used to feed the workpiece through the saw during narrow ripping-type
operation and helps keep the operator's hands well away from the blade.
A push stick should always be used if your hand gets within 125mm (5") of
the saw blade. A push stick is a safety device that helps to keep your hands
and fingers away from the saw blade. A handle helps to apply pressure to the
workpiece whilst a notch at the front of the push stick fits onto the edge of the
wood to help push it through the saw. A push stick can be easily made from a
scrap piece of material. The push stick must be narrower than the workpiece.
Always store the push stick on its holder on the front of the table when it is
not in use.
ATTACHING THE PULL HANDLE
Locate handle onto body.
Fix handle using cross head screws supplied.
Tighten until firmly secure.
ATTACHING THE FEET
Locate the plastic feet on each corner of the base.
Fix feet using the screw, spring and flat washers supplied.
Tighten screw until feet are firmly secure.
SWITCHING THE UNIT ON AND OFF
To turn the laminate saw ON, press the top half of the ON/OFF switch (3) in.
To turn the laminate saw OFF, press the bottom half of the ON/OFF switch (3) in.
To lock the laminate saw, remove the yellow key.
21