Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Dust extraction
Optional accessory
Use the vacuum head for dust extraction.
Fig.20
► 1. Vacuum head
Installing the vacuum head
1
2
Fig.21
► 1. Support 2. Lock lever
1.
Raise the lock lever of the vacuum head.
2.
Place the vacuum head on the tool base so that its
top will be caught in the hook on the tool base.
3.
Insert the supports on the vacuum head into the
hooks on the front of the tool base.
4.
Push down the lock lever onto the tool base.
5.
Connect a vacuum cleaner to the vacuum head.
Fig.22
Removing the vacuum head
1.
Raise the lock lever.
2.
Pull the vacuum head out of the tool base while
holding the supports between thumb and finger.
MAINTENANCE
CAUTION:
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
1
alcohol or the like. Discoloration, deformation or
cracks may result.
Replacing carbon brushes
Fig.23
► 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1.
Use a screwdriver to remove the brush holder
caps.
2.
Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
Fig.24
► 1. Brush holder cap
9 ENGLISH
Always be sure that the tool is
Never use gasoline, benzine, thinner,
1
1
Publicité
Table des Matières
