Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Straight guide (Type B)
Optional accessory
Insert the straight guide into the holes in the tool base
and tighten the thumb screw. To adjust the distance
between the router bit and the straight guide, loosen the
thumb screw. At the desired distance, tighten the thumb
screw to secure the straight guide in place.
Wider straight guide of desired dimensions may be
made by using the convenient holes in the guide to bolt
on extra pieces of wood.
1
2
Fig.10
► 1. Thumb screw 2. Straight guide
When using a large diameter router bit, attach pieces
of wood to the straight guide which have a thickness of
more than 15 mm (5/8") to prevent the router bit from
striking the straight guide.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
C
A
2
Fig.11
► 1. Straight guide 2. Wood
A=55 mm (2-3/16")
B=55 mm (2-3/16")
C=15 mm (5/8") or thicker
Templet guide
The templet guide provides a sleeve through which the
router bit passes, allowing use of the tool with templet
patterns. To install the templet guide, loosen the screws
on the tool base, insert the templet guide and then
tighten the screws.
1
B
Fig.12
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
3
Fig.13
► 1. Templet guide 2. Screws 3. Base plate
NOTE: The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the router bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - router bit diameter) / 2
2
3
4
5
Fig.14
► 1. Router bit 2. Base 3. Templet 4. Workpiece
5. Distance (X) 6. Outside diameter of the templet
guide 7. Templet guide
7 ENGLISH
1
7
6
1
2
Publicité
Table des Matières
