Troubleshooting; Additional Information - Rehau EVERLOC+ XL Manuel D'instruction

10. TROUBLESHOOTING

Observation Cause
Motor does not run Tool/battery contacts dirty
Tool/battery contacts damaged
Battery not correctly locked into the tool
Battery empty
Battery malfunction
Tool malfunction
Tool loses oil Leak in oil tank or release valve
Tool does not reach Leak in oil tank or release valve
initial pressure
Air in the hydraulic system
Tool malfunction

11. ADDITIONAL INFORMATION

For Professional Use Only
Proper preparation and installation is the responsibility of the installing
contractor. Only trained personnel should operate this tool. Persons using the
EVERLOC+ XL expander tool must be experienced and appropriately
licensed professional contractors who understand the principles and practices
associated with the proper installation of hot- and cold-water potable and
hydronic systems.
Battery and Charger
For use only with Makita BL1830B, BL1840B or BL1850B batteries. Charge
only with the chargers specified by Makita. Read and follow all safety
warnings and instructions in the product information accompanying the battery
and charger.
Engineering Changes
Because REHAU believes in the continual improvement of its products,
engineering changes are made from time to time. Therefore, some changes
or improvements may not be covered in this manual. If you have questions
about operating characteristics or features that are different from those
described in this manual, please contact the REHAU distributor in your area
for assistance.
Product Standards
The tool with the attached battery is certified/listed under
UL 62841-1 and CSA C22.2.
The charger specified in this instruction manual is certified/listed under
UL 1012 and CSA 22.2 No. 107.2.
Other Symbols on the Power Tool
Volt
18V
Direct Current
Do not dispose of in the household trash.
REHAU Technical Guidelines
For a full list of REHAU Technical Guidelines, please visit
www.na.rehau.com/resourcecenter.
Correction
Clean contacts when dry with a soft, dry cloth or brush
Send tool/battery to the service center
Re-insert battery; pay attention to locking mechanism
Charge battery
Send battery to the service center or have it recycled
Send tool/battery to the service center
Do not open the tool and do not remove or damage the tool seal; send tool to the
service center
Do not open the tool and do not remove or damage the tool seal;
send tool to the service center
Interrupt the process. Hold release button under tension and at the same time
continuously actuate the operating trigger for about 10 seconds. If this does not
correct the malfunction, send tool to the service center
Send tool to the service center
Disposal
This product must not be disposed of in the household trash, but only in
accordance with local, state, and federal laws and regulations. Take the
power tool, accessories, and packaging to an approved disposal site for
environmentally friendly recycling.
Recycle depleted batteries promptly. Follow instructions in the Makita
instruction manual for recycling the battery and charger.
Limited Warranty
This product is sold subject to the REHAU PEXa Limited Warranty, available
at www.na.rehau.com/warranties. It can also be obtained from your autho-
rized REHAU distributor or by writing to REHAU Construction LLC, 1501
Edwards Ferry Road NE, Leesburg VA 20176 US.
Refer to the REHAU PEXa Limited Warranty for more information.
When sending parts for service, include original purchase documentation.
Contact Makita directly for warranty terms and conditions for the battery and
charger.
Trademarks
EVERLOC and RAUPEX
®
license by REHAU Construction LLC.
Makita is a trademark of Makita Corporation, or an affiliate thereof.
®
This listing of trademarks is partial and is subject to change. Any unauthor-
ized use of these trademarks without express written consent is strictly
prohibited.
Customer Support
For customer support, contact your nearest REHAU Construction Sales
Office, available at www.na.rehau.com/contact
are registered trademarks and are used under
®
9