B Trim; Auto Bpm Counter/Effector - Denon DN-D6000 Mode D'emploi

B TRIM

9
• The Seamless Loop and Sampler B points can be fine-adjusted using the Scratch Disc.
• Trim the points during loop playback as a rehearsal.
w r q e
,
B Trim
q When the NEXT TR./B TRIM button is
pressed during seamless loop playback,
the B TRIM mode is turned on.
When the NEXT TR./B
TRIM is pressed during
playback,the NEXT TRACK
mode is set. If the button
1 is pressed again without
performing the NEXT
TRACK mode operation,
the B TRIM mode is
selected.
Select B point
w The A button illumination
automatically flashes for the
last loop created or
accessed.
2
• Or the A button or the SAMP button is
selected pressing.
Trim B point
e Turn Scratch Disc slowly to
move the B point 1 frame at
a time.
• Range for trimming B point is limited as
follows.
B point for Loop:
Between 5 frames after A point and
3
disc end.
B point for Sampler:
Between 5 frames after A point and
Sampler end.
*MP3
Between 5 frames after A point and file
end.
Save the B point
r Push the A or SAMP button
again to save new B point,
4
and the unit automatically
exit from the B Trim mode.
AUTO BPM COUNTER / EFFECTOR
10
AUTO BPM COUNTER
q w e
, ,
AUTO BPM COUNTER
Beats per minute (BPM) of a track is measured automatically and displayed during playback or in Cue
standby mode.
Measured BPM values are synchronized with the effector parameters such as:(ECHO/LOOP and FLANGER
time)
• When Auto BPM COUNTER is off, pushing the TAP button for 1 second, reactivates the AUTO BPM
COUNTER to turn back on.
• If you change or select a new track, the old BPM is cleared and the Auto BPM Counter starts to detect the
new track automatically.
NOTE:
AUTO BPM COUNTER might not be able to be measured correctly according to the music.
*If this happens, please use the TAP feature.
BPM LOCK
The data measured by the auto
BPM counter is locked.
1
q Push the TAP button once
while auto BPM counter is
operating.
"BPM Lock" is displayed for 1 second.
TAPPING
The interval when the TAP
button is pushed repeatedly is
measured and BPM is
calculated.
2
w When you push the TAP
button, the auto BPM
counter turn off.
Push the TAP button repeatedly about
5~10 times according to the beat.
r
t
,
MANUAL INPUT
The known BPM can be dialed
in directly by the numerical
value.
e The BPM manual input
mode is available when the
TAP button is pushed for
more than 2 sec. "Manual
In" is displayed is the
3
screen.
r You can input BPM value
directly with the
PARAMETERS knob.
t When the TAP button is
pushed again, the BPM
manual input mode is
turned off and the BPM is
locked to that value.
ENGLISH
15