Connection Diagrams - Denon DJ SC6000 PRIME Guide D'utilisation

Setup
Important: Occasionally, we may update SC6000 PRIME's firmware to add exciting new features and
improvements. Visit denondj.com/downloads
update your software (firmware updates may address new software features).
1. Visit enginedj.com/downloads
2. Double-click the .exe (Windows
screen instructions to install Engine DJ.
3. Make sure all of your devices are powered off or all of their volume levels are at their minimum positions.
4. Connect SC6000 PRIME's audio outputs (Layer A/B or Digital Outputs A/B) to the inputs of your mixer.
5. Connect SC6000 PRIME's Link ports according to one of the following connection diagram examples.
6. Connect any output devices (headphones, power amplifiers, loudspeakers, etc.) to the outputs of your mixer.
7. Connect all of your devices to power sources.
•
When starting a session, power on (1) SC6000 PRIME and other input sources, (2) your mixer, and then (3)
output devices.
•
When ending a session, power off (1) output devices, (2) your mixer, and then (3) SC6000 PRIME and
other input sources.
8. To use Engine OS (standalone playback): Insert a USB flash drive or SD card (with an Engine-configured
music library) to one of SC6000 PRIME's USB ports or SD Card Slot.

Connection Diagrams

Items shown but not listed under
Example 1
This example shows 2 SC6000 PRIME units with their Link ports connected to each other directly.
SC6000 PRIME
(rear panel)
Power outlet
USB drive
4
to check for available firmware updates, especially after you
to download the Engine DJ software.
®
) or .dmg (macOS
Introduction > Box Contents
Denon DJ mixer
(rear panel)
SD card
®
) installer file you downloaded, and then follow the on-
are sold separately.
Power outlet
SC6000 PRIME
(front panel)
USB drive
SC6000 PRIME
(rear panel)