Functional Description - Makita DLM380 Manuel D'instruction

FUNCTIONAL DESCRIPTION

Installing or removing battery cartridge
CAUTION:
Always switch off the tool before installing or
•
removing the battery cartridge.
Make sure that you lock the battery cover before
•
use. Otherwise, mud, dirt, or water may cause
damage to the product or the battery cartridge.
Always install the battery cartridge fully until the
•
red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
NOTE:
The tool does not work with only one battery
•
cartridge.
To install the battery cartridge;
1. Pull the battery cover locking lever toward
yourself and open the battery cover.
1
2
014484
2. To install the battery cartridge, align the tongue
on the battery cartridge with the groove in the
housing and slip it into place. Insert it all the way
until it locks in place with a little click. If you can
see the red indicator on the upper side of the
button, it is not locked completely.
1
2
014504
3.
014485
4.
To remove the battery cartridge from the mower;
1.
2.
3.
4.
Battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to the
motor to extend tool and battery life.
1. Battery cover
The tool will automatically stop during operation if the
locking lever
2. Battery cover
tool or battery is placed under one of the following
conditions. In some conditions, the indicators light up.
Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indication. In this situation, turn the
tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
Overheat protection
When the tool or battery is overheated, the tool stops
automatically without any indications. The tool does not
start even if turning on the tool. In this situation, let the
tool or battery cool before turning the tool on again.
1. Battery cover NOTE:
2. Battery cartridge
The battery overheat protection works only with a
battery cartridge with a star marking. The tool overheat
protection system works with any battery cartridges.
012128
5
Insert the lock key in the place shown in the
figure as far as it will go.
1
2
Close the battery cover and push it on until it is
latched with the locking lever.
Pull the battery cover locking lever toward
yourself and open the battery cover.
Slide it from the tool while sliding the button on
the front of the cartridge.
Pull out the lock key.
Close the battery cover.
1
1. Battery cartridge
2. Lock key
1. Star marking