Safety Information - SEFRAM MW 3031 Notice D'utilisation

 Safety Information
To ensure safe operation and service of the
Tester, follow these instructions.
Failure to observe warnings can result in
severe injury or death.
- Avoid working alone so assistance can be
rendered.
- Do not use test leads or the Tester if they
look damaged.
- Do not use the Tester if the Tester is not
operating properly or if it is wet.
- Use the Clamp Meter only as specified in
the Instruction card or the protection by
the Clamp Meter might be impaired.
- Individual protective device must be used
if hazardous live parts in the installation
where the measurement is to be carried
out could be accessible.
- Use caution with voltages above 30 V ac
rms, or 60 V dc. These voltages pose a
shock hazard.
Symbols as marked on the Tester
and Instruction card
 Risk of electric shock
 See instruction card
Equipment protected by double or

reinforced insulation
< Battery
 Earth
 Conforms to EU directives
Application around and removal from
hazardous live conductors is
E
permitted
Do not discard this product or throw
away
15