Maintenance; Adjusting The Guide Handle; Tilting The Machine; Replacing The Polishing Disk - Schwamborn EU 430 Traduction Du Manuel D'utilisation Original

EN EU 430 / EU 510
High‐speed floor polishing machine

4 Maintenance

4 Maintenance
Observe the safety instructions in Chapter 2!
Maintenance work may only be performed by
trained specialists! They must be familiar with
the dangers associated with such work, protect
themselves and avoid danger!
When working on the machine (set‐up, mainte­
nance, service, repair, cleaning, etc.), the power
supply of the machine has to be disconnected
from the mains
(Pull the power plug from the socket)!
Perform cleaning and maintenance work in ac­
cordance with the operating manual and check
the safety equipment for completeness and
functionality!

4.1 Adjusting the guide handle

(! Fig. B)
1. Hold the guide handle [4, Fig. A].
2. Step on the release pedal [7, Fig. A].
The guide handle is unlocked.
3. Swivel the guide handle into the desired posi­
tion.
V Vertical position
W Work position
X Work position
Y Horizontal position
Z Park position
4. Free the release pedal.
The guide handle clicks into place and is locked.

4.2 Tilting the machine

The vertical position of the guide handle is in­
tended for changing the polishing disk, mainte­
nance and transport.
Before tilting the machine, always make sure
that it is on an even, level floor surface!
1. Pull the power plug [11, Fig. A] from the socket.
2. Swivel and lock the guide handle [4, Fig. A] into
vertical position
(! Chapter 4.1, page 17).
3. Tilt the machine backwards and place it on the
floor using the guide handle.

4.3 Replacing the polishing disk

There are many different polishing disks available
from the manufacturer that are tailored to the ma­
chine.
The consistency of the surface to be treated de­
termines the type or composition of the polishing disk
to be used.
Do not use any tools to replace the polishing disk!
(! Fig. F)
1. Stop operation (! Chapter 3.3, page 16).
2. Tilt the machine (! Chapter 4.2, page 17).
The fixing plate has a left‐hand thread!
3. Turn the fixing plate [20] clockwise (—) and
remove it.
4. Remove the polishing disk [19].
5. Press the new polishing disk centrally onto the
drive plate [18].
6. Tighten the fixing plate by turning it anti‐clock­
wise (+).
7. Set the machine upright.

5 Acceptance and transportation

Observe the safety instructions in Chapter 2!

5.1 Machine acceptance

The machine is supplied in a complete and packaged
condition from the manufacturer.
1. Unpack machine and check the enclosed
delivery slip to make sure all parts are delivered.
2. In case of damage, contact the transport com­
pany promptly!
3. If necessary, report any problems to the manu­
facturer immediately!
Complaints at a later date cannot be acknowled­
ged!
17