Safety Instructions - Schwamborn EU 430 Traduction Du Manuel D'utilisation Original

EN EU 430 / EU 510
High‐speed floor polishing machine
2 Safety
All laws and regulations (e.g. the valid regulations on
waste disposal), accident prevention guidelines and
generally recognised safety rules must be complied
with when working on and with the machine.

2.2 Safety instructions

This machine incorporates state of the art technology
and has been built in accordance with recognised
safety regulations. This ensures that the highest pos­
sible standards of occupational safety are main­
tained. However, incorrect use of the machine could
endanger the health and lives of the personnel or
cause material damage.
The machine may only be operated by persons
who have been assigned to do so and who have
the appropriate training and skills.
If any defects are found in the machine that
could endanger persons or damage property,
stop the machine immediately and ensure that it
cannot be used again until all repairs are com­
pleted.
The operating and maintenance personnel resp­
onsible for the machine must ensure that no one
can enter the machine's danger zone during
operation or maintenance work.
Persons with pacemakers are not permitted to
work with the machine!
Risk of injury if safety equipment has been
removed or is not working!
The safety equipment must be checked for com­
pleteness and function before starting up.
The safety equipment must be mounted during
operation.
Safety equipment must not be prevented from
functioning!
The surfaces to be processed by the machine
must be free of obstacles.
14
Risk of injury from rotating machine parts!
Limbs and clothing can be drawn in.
Proceed with the greatest care and caution!
High‐voltage electrical current can be fatal!
Risk of injury and fire due to faulty electrical ca­
bles!
Only connect the machine to power supplies
equipped with a ground fault circuit breaker
(type B)!.
Connections with mains cables
must be protected from splash water!
Mains cables and power plugs must undergo a
functional safety check prior to start‐up!
Only suitably knowledgeable, qualified profes­
sional electricians may perform work on any
electrical parts of the system!
When performing work on/with the machine,
watches and jewellery (e.g. rings, earrings,
chains) may not be worn!
When working on the machine (set‐up, mainte­
nance, service, repair, cleaning, etc.), the power
supply of the machine has to be disconnected
from the mains
(Pull the power plug out of the power socket)!
Risk of poisoning due to harmful substances at
the workplace!
Eating, drinking and smoking at the workplace is
not permitted. Always eat in break rooms or
canteen areas!
A general inspection of the machine must be
conducted before starting up the machine. Parti­
cular attention should be paid to damaged or
loose components, and wear.
The machine may only be put into operation in
perfect technical condition.
Adding to or modifying the machine in any way
that could compromise operating safety is prohi­
bited!