Adjust The Exhaust Adaptor; Connecting Ductwork - Danby Designer DOM161KBLSDD Guide D'utilisation Et D'entretien

MOUNT THE MICROWAVE
OVEN (cont.)
Cabinet Front
A4
Cabinet Bottom Shelf
Microwave Oven Top
4
Attach the microwave oven to the top cabinet
Insert 2 self-aligning screws through outer top
5
cabinet holes. Turn two full turns on each screw.
Tighten the outer two screws to the top of the
7
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Install grease filters. See the Owner's Manual
8
packed with the microwave.
INSTALLATION INSTRUCTIONS
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
6 Tighten center Tighten center
6
screw completely.
screw completely.
ADJUST THE EXHAUST
ADAPTOR
A5
Open the top cabinet and adjust the exhaust adaptor
to connect to the house duct.
Blower Plate
CONNECTING THE DUCTWORK
A6
Extend the house duct down to connect to
1
the exhaust adaptor.
Seal exhaust duct joints using duct tape.
2
14
Back of
Damper
Microwave
For Front-to-Back or
Side-to-Side Adjustment,
Slide the Exhaust Adaptor
as Needed
House Duct