Publicité
PLACEMENT OF
1
THE MOUNTING PLATE
REMOVING THE MICROWAVE OVEN
A
FROM THE CARTON/ REMOVING THE
MOUNTING
PLATE
1. Remove the installation instructions, filters, glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
2. Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
Screws
Remove the screws from the mounting plate. This plate
will be used as the rear wall template and for mounting.
You may discard these screws.
INSTALLATION INSTRUCTIONS
Carton
Mounting
Plate
FINDING THE WALL STUDS
B
Wall
Studs
Center
1. Find the studs, using one of the following methods:
A. Stud finder – a magnetic device which locates nails.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate a stud location.
2. After locating the stud(s), find the center by probing the
wall with a small nail to find the edges of the stud. Then
place a mark halfway between the edges. The center of
any adjacent studs should be 16'' or 24'' from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
8
OR
Publicité
Chapitres
Dépannage
