Publicité
OUTSIDE TOP EXHAUST
A
(Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Damper Operation
A4. Mount Microwave Oven
A5. Adjust Exhaust Adaptor
A6. Connect Ductwork
ATTACH THE MOUNTING
PLATE TO THE WALL
A1
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
toggle wings to 3/4'' onto each bolt.
INSTALLATION INSTRUCTIONS
TO USE TOGGLE BOLTS
3. Place the mounting plate against the wall and insert the
toggle wings into the holes in the wall to mount the
plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the bottom
of the cabinet when pushed flush against the wall and that
the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between
the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
Toggle Wings
Mounting
Plate
Wall
12
Spacing for Toggles
More Than Wall
Thickness
Toggle
Bolt
Bolt End
Publicité
Chapitres
Dépannage
