Télécharger Imprimer la page

Installing The Charcoal Filter - Danby Designer DOM161KBLSDD Guide D'utilisation Et D'entretien

Publicité

INSTALLATION INSTRUCTIONS
MOUNT THE MICROWAVE OVEN
(cont.)
C5
Insert 2 self-aligning screws through outer top cabi-
5
net holes. Turn two full turns on each screw.
Tighten the outer two screws to the top of the
7
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Install grease filters. See the Owner's Manual
8
packed with the microwave.
Tighten center
6 Tighten center
6
screw completely.
screw completely.
22
INSTALLING THE
CHARCOAL FILTER
C6
Remove screws on top of out case using a #1
1
Phillips screwdriver.
2
Open the door
3
Remove the grill
Pull the grill straight off.
Install the charcoal filter. When properly installed,
4
the wire mesh of the filter should be visible from
the front.
5
Replace the grille and the screws.
6
Close the door
Insert mesh-side up
Charcoal
Filter

Publicité

Chapitres

loading