Sensitec NF-3101 Mode D'emploi page 15

Table 202 - Declaration - electromagnetic immunity
Guidance and manufacturer's declaration — electromagnetic immunity
The Model Number or Type Number - by manufacturer is intended for
use in the electromagnetic environment specified below. The customer or
the user of the Model Number or Type Number - by manufacturer should
assure that it is used in such an environment.
Immunity test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Table 204 - Declaration - electromagnetic immunity
Guidance and- manufacturer's declaration. Electromagnetic immunity
The Model Number or Type Number - by manufacturer is intended for use
in. the electromagnetic environment specified below. The customer or
the user of the Model Number or Type Number - by manufacturer should
assure that it is used in such an environment.
Immunity test
Electromagnetic environment - guidance
Portable and mobile RF communications equipment should be used no
closer to any part of the Model Number or Type Number - by manufacturer,
including cables, than the recommended separation distance calculated
from the equation applicable to the frequency of the transmitter.
IEC 60601 test
level
± 6 kV contact
± 8 kV air
IEC 60501 test
level
Compliance
level
± 6 kV contact
± 8 kVair
Compliance
level
English 15
Electromagnetic
environment -
guidance
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material,
the relative humidity
should be at least
30 %.