Technical Details - Micro Kickboard original KB 0005 Manuel De L'utilisateur

Technical Details

Brake
The brake is a friction brake and only designed for reduction of speed on flat surfaces - avoid going downhilI. Brake
at low speed by gently pushing your foot, resting far back on the board, against the back wheel plate. You need
to push harder if you are travelling faster. Be careful however: if you push the brake too hard and slow down
too abruptly, you risk falling. Its best to practise braking at walking speed.
use.
kickboard compact KB0006
Put lhe handle bar with the black push button positioned at the front - into the tube and turn slightly to the
left and right hand side until you can hear the snap of the clamp. Pull handlebar firmly up in order to check if it
is locked into placed securely. In order to remove the handlebar, press the black push button completely in and pull
the handlebar in straight direction outward.
Attention: The brake and protection plate can get very hot.
Easy Fold
Pull the sliding sleeve towards the rubber knob before unfolding the steering rod. Be careful not to
exert sideways force on the steering rod. The stop pin disengages. After you have moved the steering
rod upwards about 15°, release the sliding sleeve. Unfold the rod upwards, until the sliding sleeve
engages in the upper position with an audible click. Release the quick lock mechanism beneath the
rubber knob and extend lhe telescopic rod. Tighten the quick lock. The micro kickboard is now ready for
15