Applications; Conformity And Approval; Inserting Batteries - Monacor International JTS TG-16RA /1 Mode D'emploi

Tour Guide System
These instructions are intended for users without any specific
technical knowledge Please read the instructions carefully prior
to operation and keep them for later reference All operating ele-
ments and connections described can be found on pages 2 and 3

1 Applications

Combined with a receiver or several receivers of the type
TG- 16RA /1, the transmitter TG-16TA /1 creates a mobile wireless
voice transmission system, e g for guided tours or lectures in
various languages For wireless transmission, 16 channels are
available in the range 863 – 865 MHz; up to 3 of these channels
may be used at the same time without mutual interference The
transmission range depends on local conditions; the maximum
range is 100 m

1.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that the transmitter
TG-16TA /1 and the receiver TG- 16RA /1 comply with the directive
2014 / 53 / EU The EU declarations of conformity are available on
request from MONACOR INTERNATIONAL
The wireless transmission system is generally approved for
operation in EU and EFTA countries; it is licence-free and requires
no registration
2 Important Notes
The transmitter/receiver corresponds to all required directives of
the EU and is therefore marked with
•
The transmitter/receiver is suitable for indoor use only Protect
it against dripping water, splash water and high air humidity The
admissible ambient temperature range is 0 – 40 °C
•
For cleaning only use a dry, soft cloth; never use water or chem-
icals
•
No guarantee claims for the transmitter/receiver and no liability
for any resulting personal damage or material damage will be
accepted if the transmitter/receiver is used for other purposes
than originally intended, if it is not correctly operated, or if it is
not repaired in an expert way
If the transmitter/receiver is to be put out of operation
definitively, take it to a local recycling plant for a disposal
which is not harmful to the environment
3 Setting up

3.1 Inserting batteries

For power supply, two 1 5 V batteries (or two rechargeable 1 2 V
NiMH batteries) of size AA are required
•
Only insert batteries of the same type and always replace both
of them
•
If the transmitter/receiver is not in use for a longer period of
time, always remove the batteries as a precaution to prevent
damage due to battery leakage
Open the battery compartment on the rear: Slightly press the
marking on the cover (7) and push the cover downwards Insert
the batteries with the positive and negative poles as indicated in
the compartment Then close the compartment
Never put batteries in the household waste; always take
them to a special waste disposal, e g collection container
at your retailer
3.2 Connecting the earphone to the receiver
When the earphone provided is connected to the receiver, the
internal speaker (3) will be switched off Wrap the foam cover
around the earphone as a padding: Put the earphone (with the JTS
logo to the rear) into the unprinted pocket of the cover Wrap the
cover around the earphone and slip the second pocket over it The
printing
earphone to the jack
6
will mark the side where sound is emitted Connect the
(5) and attach the earphone to your ear