Steering Friction Adjusting Screw (For Tiller Control Model); Trim Angle Adjusting Rod; Tilt Lock Mechanism (For Manual Tilt Model) - Yamaha F6AMH Manuel D'utilisation

EMU00108
STEERING FRICTION ADJUSTING
SCREW (for Tiller control model)
A friction device provides resistance to
steering movement. This is adjustable for
operator preference. An adjusting screw/bolt
is located on the swivel bracket.
EMU01296
Adjustment
Resistance
Increase
Decrease
WARNING
@
Do not over tighten the friction screw/
bolt. If there is too much resistance, it
may be difficult to steer, which could
result in an accident.
@
EMU01297

TRIM ANGLE ADJUSTING ROD

The position of the trim angle adjusting rod
determines the minimum trim angle of the
outboard motor in relation to the transom.
EMU00152
TILT LOCK MECHANISM (for Manual
tilt model)
The tilt-lock mechanism is used to prevent
reverse thrust from the propeller lifting the
outboard motor when reversing.
To lock it, set the tilt-lock lever in the up posi-
tion.
To release it, push the tilt-lock lever down.
1 Tilt-lock lever
2-31
Screw/Bolt
Turn clockwise
Turn counterclockwise
GB