Yamaha F6AMH Manuel D'utilisation page 116

EMU01414
Power Tilt Model
WARNING
@
G Be sure all people are clear of the out-
board motor when adjusting the tilt
angle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
G
Use caution when trying a trim posi-
tion for the first time. Increase speed
gradually and watch for any signs of
instability
Improper trim angle can cause loss of
control.
G Use the power tilt switch located on
the bottom
equipped) only when the boat is at a
complete stop with the engine off.
@
1) Place the gear-shift lever in the neutral
position.
2) Tilt the engine to the desired angle
using the power tilt switch.
NOTE:
@
Stay within the trim operating angle when
trimming the outboard motor using the
power tilt system.
@
To raise the bow ("trim-out"), tilt the engine
up.
To lower the bow ("trim-in"), tilt the engine
down.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
3-45
or control problems.
engine cowling
GB
(if