Troubleshooting - Danby Designer DPA110B2WDD Guide D'utilisation Et Soins De Propriètaire

Troubleshooting

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this trou-
bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby's Toll Free Number 1-800-263-2629 for assistance.
PROBLEM
Unit does not start
when pressing on/off
button
Not cool enough
Noisy or vibration
Gurgling sound
DISPOSAL
Check for local regulatory compliance regarding the approved and safe disposal of this appliance.
POSSIBLE CAUSE
P1 appears in the display window
Room temperature is lower than
the set temperature (cooling mode).
The windows or doors in the room
are not closed.
There are heat sources inside the
room.
Exhaust air hose is not connected or
is blocked.
Temperature setting is too warm.
Air filter is blocked by dust.
The ground is not level or not flat
enough.
The sound comes from the flowing
of the refrigerant inside the
air conditioner
16
SOLUTION
Drain the water in the bottom tray.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if possible.
Connect the hose and make sure it
can function properly.
Decrease the set temperature.
Clean the air filter.
Place the unit on a flat, level ground
if possible.
It is a normal operations sound.